Ford Archives - Page 3 of 6

2014 Ford Edge
Mileage
91,842
Service Date
8/12/2023
Services Performed
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
CALIPER – Remove & Replace – Front,One Side – [Includes: Bleed Brake System and replace Pads (if necessary).]
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
TIE ROD &/OR END – Remove & Replace – Inner – [Includes: R&I Steering Gear Assembly.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing In
TIE ROD &/OR END – Remove & Replace – Outer – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If remo
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
HEADLAMP BULB – Remove & Replace – One – [DOES NOT include adjust Headlamps.]
Rene B. gave our service a 5 star review on 8/15/2023
2017 Ford F-250 Super Duty
Mileage
152,751
Service Date
8/3/2023
Services Performed
Remove broken flange section. Fabricate new pipe and mig weld all connections parts and labor
Joe O. gave our service a 5 star review on 8/3/2023
2010 Ford Mustang
Mileage
84,879
Service Date
7/31/2023
Services Performed
Install new catalytic converter. Mig weld all connections parts and labor
Install new catalytic converter. Mig weld all connections parts and labor
Glenn D. gave our service a 5 star review on 7/31/2023
2015 Ford Escape
Mileage
145,922
Service Date
7/10/2023
Services Performed
ENGINE OR TRANSMISSION MOUNT – Remove & Replace – 1.6L Eng Trans Mount
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
Lafayette C. gave our service a 5 star review on 7/10/2023
2014 Ford Escape
Mileage
209,122
Service Date
7/3/2023
Services Performed
TRANSFER CASE ASSEMBLY – Remove & Replace – 1.6L Eng
Patricia L. gave our service a 5 star review on 7/7/2023
2004 Ford Econoline
Mileage
118,465
Service Date
6/23/2023
Services Performed
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
BALL JOINT – Remove & Replace – E150,E250 Both Sides,Upper & Lower – [DOES NOT include alignment.]
CENTER LINK – Remove & Replace – [DOES NOT include alignment (unless noted otherwise).]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
Patrick B. gave our service a 5 star review on 7/5/2023
2004 Ford Mustang
Mileage
11,335
Service Date
6/8/2023
Services Performed
Install customer supplied sub frame connections. Prep surface and weld subframe connectors.
Bohdan S. gave our service a 5 star review on 6/8/2023
2020 Ford Fusion
Mileage
66,928
Service Date
6/6/2023
Services Performed
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures.
Michelle M. gave our service a 5 star review on 6/6/2023
2013 Ford Fusion
Mileage
159,045
Service Date
6/2/2023
Services Performed
TIE ROD &/OR END – Remove & Replace – Outer,One Side – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
CONTROL ARM – Remove & Replace – Lower,One,w/o Vehicle Dynamic Suspension – [DOES NOT include alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Left – [Includes: Replace Axle Shaft Seal.] – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
BRAKE VACUUM PUMP – Remove & Replace – 2.0L Eng,Turbocharger
Rob C. gave our service a 5 star review on 6/3/2023
2016 Ford Focus
Mileage
70,638
Service Date
5/31/2023
Services Performed
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
CONTROL ARM – Remove & Replace – Normally Aspirated Lower,Both – [DOES NOT include alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel.
Amy K. gave our service a 5 star review on 6/3/2023

Ford

We Service and Repair all Ford cars